DenTek Temparin Max Twin Pack
Temparin max is designed to repair lost fillings, caps, crowns or inlays with the same ingredients dentists use. This is a temporary remedy for use until you have chance to visit your dentist and should be removed by a dental professional. This solution provides instant pain relief, the kit contains the temparin max one step formula and a dual end no mess applicator.
Temporarily hold lost fillings and inlays in place until you have a chance to visit the dentist with DenTek® Temparin Max.
- Contains the same maximum-strength ingredients dentists use.
- Temporarily repairs lost fillings, caps, crowns, or inlays
- Should only be removed by a dental professional, who should be seen within 48 hours of use
How do I use this temporary dental repair kit?
Directions to replace a lost filling:
Wash the cavity area with warm water and do not dry. Cut with spade tool or pinch a small amount of Temparin Max from the vial, and roll into a ball between fingers. Slightly overfill the cavity with Temparin Max and tamp into place with applicator tool tip. Close your teeth together, as if you were biting down on a piece of paper, and gently chew or grind on the replaced filling a couple times to create a comfortable bite. Use a moist cotton swab to remove excess Temparin Max from around the area. Moisture will accelerate the set. Temparin Max will set softly in your mouth within a few minutes, but avoid chewing on the repair for 2-3 hours to allow the material to fully set.
Directions to secure loose crowns, caps, or inlays:
Try the crown, cap, or inlay first to see if you can fit it accurately back onto the tooth surface. If you are not able to do so, or if remaining tooth is cracked, then do not proceed further. If the crown has a post attached to it or if there is tooth surface remaining inside the crown, Temparin Max may not adhere. Carefully rinse the tooth area and the inside of the crown, cap, or inlay with warm water, and do not dry. Cut with spade tool or pinch a small amount of Temparin Max from the vial, roll into a ball between fingers, and place evenly inside the crown, cap, or inlay. Place the crown, cap, or inlay on the tooth and bite down, applying pressure to push into position. Temparin Max will begin to harden within a few minutes, but avoid chewing on the repair for at least 2-3 hours to allow the material to set. Use a toothbrush to gently clear any excess material from around the crown, cap, or inlay.
Ingredients of Temparin Max
Zinc Oxide Powder, Calcium Sulfate, Petroleum Jelly, Potassium alum, Paraffin, Aluminum Sulphate, Aluminum Phosphate, Menthol Crystals, Eugenol, Yellow Iron Oxide